Filter
Top Products
Advanced UseTANDBERG Director Videoconferencing System
59
Dual Monitor
ON Selfview, snapshots and DuoVideo
TF
will be displayed on the 2nd monitor.
OFF The 2nd monitor shows Selfview only.
Auto-PIP
ON Your selfview will automatically be displayed (as a Picture-in-picture) whenever
the camera position or video source is changed. Picking up the remote control
will also display your selfview.
Welcome Menu
The Welcome menu can be shown when the system is not in use, and when sleep-mode is not
activated.
O
N The Welcome Menu is shown when the system is not in sleep mode.
OFF The Welcome Menu is not shown.
LOGO If a logo is uploaded to the system, it will be shown when this button is selected.
See also APPENDIX 5.
Continuous Presence
ON The screen is divided into three or four
blocks, each displaying the video image of
a different participant.
OFF The active site will be displayed in full
screen during a MultiSite
TF
conference. Also
called Voice Switched mode.
MCU status line
ON The MultiSite
TF
/MCU/DuoVideo
TF
indicators will be displayed and provide
information about the conference.
OFF The MultiSite
TF
/MCU/DuoVideo
TF
indicators will not be displayed.
AUTO The MultiSite
TF
/MCU/DuoVideo
TF
indicators will be displayed for a few seconds
and then timed out. When grabbing the remote control, the indicators will be
shown again.
System Name
Identifies the system:
• during an MCU conference call.
• when using the Web-interface.
• when the codec is acting as an SNMP Agent.
• towards a DHCP server.
• as an H.323 ID. Other systems can call us using this name instead of IP-number/IP-address.
Menu Password
Enter the code which should be entered to get access to the menu system on the TANDBERG
system. When pressing the MENU button on the remote control, the user will be asked to enter the
Password written here.
TIP
TO DISPLAY YOUR SITE IN FULL
SCREEN
WHEN ‘ON’ IS SELECTED,
PRESS THE QUICK KEY ‘REQUEST
FLOOR’.
TF - TANDBERG FIRST