Filter
Top Products
Advanced Use TANDBERG Director Videoconferencing System
86
IP Settings
IP-assignment
DHCP (Dynamic Host Configuration Protocol) can be selected when a DHCP server is present.
DHCP IP-address, IP-subnet mask and Gateway are not used because these
parameters are assigned by the DHCP server.
STATIC The codec’s IP-address and IP-subnet mask must be specified in the IP-address
field.
IP-address
IP-address defines the network address of the codec. This address is only used in static mode. In
DHCP-mode, the assigned IP-address can be found on the Welcome Menu.
IP-subnet mask
IP-subnet mask defines the type of network. This address is only used in static mode. Your LAN-
administrator will provide the correct value for this field.
Gateway
When using DHCP, the default gateway will be set automatically. If the LAN utilizes static IP
addresses, IP address, subnet mask, and default gateway must be specified by the LAN
administrator.
Ethernet Speed
AUTO The codec will auto-detect the speed/duplex on the LAN.
10/HALF The codec will connect to the LAN using 10Mbps speed/Half Duplex.
10/FULL 10 Mbps speed/Full Duplex.
100/HALF 100 Mbps speed/Half Duplex.
100/FULL 100 Mbps speed/Full Duplex.
Restart
Pressing the QUICK KEY ‘Restart’ will restart your system without having to use the On/Off switch on
the codec. If IP-assignment is changed, it is sufficient to use this QUICK KEY to restart the system.
NOTE
CHANGES IN THIS MENU WILL NOT
HAVE
ANY EFFECT BEFORE THE
SYSTEM IS RESTARTED.