TANDBERG D5016402 CD Player User Manual


 
Advanced Use TANDBERG Director Videoconferencing System
82
Streaming Source
A
UTO Enables streaming of both local and far end video. Selection of which site to be
streamed is done using voice switching (the site that speaks is streamed).
L
OCAL Only the local video will be streamed.
REMOTE Only the far end video will be streamed.
Local and far end audio is always streamed.
Allow Remote Start
ON Streaming can be started from external user interfaces like the Web-browser or
Telnet session.
OFF Streaming can only be started from the Videoconferencing System using the
remote control, or by using the Dataport. This will prevent activation of
streaming using Web browser or Telnet sessions. See also ‘Password’ section
below
Announcements
ON The codec will announce to the network that it is streaming. This enables a
streaming client (e.g. a PC) to connect to the codec’s streaming session. Used
by Cisco IP/TV.
OFF No announcement packets will be transmitted.
Video Rate
Defines the Video streaming rate from the system. Range is 16kbps - 320kbps. In addition, audio
(G.711) streaming rate is 64kbps, providing a maximum streaming rate of 384kbps.
Password
Set password so that only participants entering correct password will be able to view the streaming
session. Entering a password will prevent unauthorized people from accessing the streaming
session.
Start/Stop Streaming
By pressing the QUICK KEY labeled ‘Start Streaming’, the Streaming session will start. To stop the
stream, press the same QUICK KEY, which will be labeled ‘Stop Streaming’ while the streaming-
session is active. Pressing DISCONNECT will also stop the streaming session.
How to view streaming
After streaming is started, an easy way to view the streamed audio/video is to start your Web-
browser and enter the IP-address of the streaming system. After the Web page of the codec is
shown, click on ‘Streaming’. Alternatively, enter http://<codec ip-address>/stream.sdp.