Filter
Top Products
Operation
80 Runco SC-30d/SC-35d Installation/Operation Manual
PRE
L
IMINAR
Y
Table 4-3 lists the Color Gamut settings and associated x- and y-coordinates for each
primary and secondary color component.
•PCE: To use the Personal Color Equalizer to define a custom color gamut, choose the
“PCE” Color Gamut setting (refer to Color Gamut on page 79). Then, choose PCE
from the Display Color - Common Settings menu and press ENTER.
PCE provides the ability to define a custom color gamut in terms of a “white point” and
primary (red, green, blue) color points; see Figure 4-7.
• RGBW (Red, Green, Blue, White): To precisely adjust the primary color points and
white point associated with the custom color gamut, choose RGBW from the PCE
sub-menu. Each control operates only on the color specified. Surrounding colors are
linearly interpolated based on their distance from each of these colors.
Table 4-3. x/y Color Gamut Values
Primary
Color
Color Gamut Settings and Associated x/y Values
REC709 SMPTE “C” EBU
xyxyxy
Red 0.640 0.330 0.630 0.340 0.640 0.330
Yellow 0.419 0.505 0.421 0.507 0.418 0.502
Green 0.300 0.600 0.310 0.595 0.290 0.600
Cyan 0.225 0.329 0.231 0.326 0.220 0.329
Blue 0.150 0.060 0.155 0.070 0.150 0.060
Magenta 0.321 0.154 0.314 0.161 0.328 0.158
1. The PCE setting only affects 2D content.
2. The Dimension Digital Controller uses the PCE settings for all
display modes on a given input.
Note
Display Color
RGBW
Red x 0.640
Red y 0.330
Green x 0.300
Green y 0.600
Blue x 0.150
Blue y 0.060
White x 0.313
White y 0.329
7 Auto Color Enable
7 Test Pattern Enable