Filter
Top Products
Operation
Runco SC-30d/SC-35d Installation/Operation Manual 91
PRE
L
IMINAR
Y
• Default Gateway: Select Default Gateway from the IP Configuration menu to
manually configure the default IP gateway. The procedure is similar to that for setting
the IP address.
• Communication Test: Select Communication Test from the IP Configuration menu
to verify proper operation of the network communication link.
To start the test, select Start Test from the Communication Test menu. The
Dimension Digital Controller displays the message “Performing Communication
Test.” When the test completes, the Dimension Digital Controller displays either
“Failed” (along with the error that occurred) or “Succeeded.”
• Auto Firmware Upgrade: Select Auto Firmware Upgrade from the Network menu to
enable automatic detection of a newer version of the Dimension Digital Controller
firmware. If one is found, you can configure the Dimension Digital Controller to install it
automatically. These features make it easier to keep your Dimension Digital Controller
firmware up-to-date.
• Auto Check For New Firmware: To have the Dimension Digital Controller
automatically check for firmware updates at periodic intervals, select Auto Check for
New Firmware from the Auto Firmware Upgrade menu and set it to On. If you prefer
to do this manually, set it to Off and use the Check For New Firmware sub-menu
(described below).
• Auto Perform Upgrade: If the “Auto Check For New Firmware” process
determines that a newer firmware version than the one currently installed is available,
you can have the Dimension Digital Controller automatically download and install it.
To do this, select Auto Perform Upgrade from the Auto Firmware Upgrade menu
and set it to On. The upgrade will occur the next time the Dimension Digital
Controller is “power-cycled” (powered off, then on again). If you prefer to do this
manually, set it to Off. The Dimension Digital Controller will ask if you want to
perform the upgrade the next time it is power-cycled.
• Check For New Firmware: To have the Dimension Digital Controller check for new
firmware on demand (and perform an upgrade if it finds a new version), select Check
For New Firmware from the Auto Firmware Upgrade menu. If the Dimension Digital
Controller finds a new firmware version, select Yes to perform the upgrade or No to
return to the previous menu.