Filter
Top Products
Installation
28 Runco SC-30d/SC-35d Installation/Operation Manual
PRE
L
IMINAR
Y
Other Considerations Other considerations and tips that can help improve your installation:
• Keep the ambient temperature constant and below 35°C (95°F). Keep the projector
away from heating and/or air conditioning vents. Changes in temperature may cause
drifts in the projector circuitry, which may affect performance.
• Keep the projector away from devices that radiate electromagnetic energy such as
motors and transformers. Common sources of these include slide projectors,
speakers, power amplifiers and elevators.
3.4
Installing the Primary
Projection Lens
The primary projection lens is shipped separately from the projector. Tto install it, proceed
as follows:
1. Carefully remove the projector from the
shipping container and place it on a flat
surface.
2. Loosen the Phillips screws at the bottom
and top of the decorative bezel on the front
of the projector.
3. Grasp the bezel by the front, then slide it
forward to remove it.
4. Carefully remove the lens from the shipping container.
5. Remove the rear cap from the lens. This protective cap is only used during shipping to
protect the lens from damage.
➤