Filter
Top Products
Installation
Runco SC-30d/SC-35d Installation/Operation Manual 51
PRE
L
IMINAR
Y
3.10
Primary Lens
Adjustments: Focus,
Zoom and Position
Lens zoom and focus are motorized adjustments that are adjustable using the remote
control (Figure 2-6). This allows you to adjust the focus and image size while at the screen
for more accurate results.
To access the motorized lens controls:
1. On the Dimension Digital Controller remote control or front panel, press MENU.
2. Select Service from the Main Menu and enter the Service Menu passcode.
3. Select Display Device from the Service Menu.
4. Select Configure from the Display Device menu, then select Lens.
The Lens menu controls operate as described below.
FocusTo focus the projected image, use the cursor buttons to highlight “In” or “Out.” Then,
press and hold the ENTER button.
ZoomTo make the picture smaller (zoom out), use the cursor buttons to highlight the minus sign
(-). Then, press and hold the ENTER button.
To enlarge the picture (zoom in), use the cursor buttons to highlight the plus sign (+).
Then, press and hold the ENTER button.
Vertical and Horizontal
Lens Shift
To change the projected image position, use the lens adjustment tool provided with the
SC-30d/SC-35d to shift the lens in the desired direction; see Figure 3-26. The vertical lens
shift control is at the top of the projector; the horizontal lens shift control is on the side of
the projector farthest from the Runco logo.
Figure 3-26. Vertical and Horizontal Lens Shift Adjustments
You must enter a passcode to access the Service menu.
Note
V
ertical Lens Shift
Horizontal Lens Shift