Filter
Top Products
Operation
76 Runco SC-30d/SC-35d Installation/Operation Manual
PRE
L
IMINAR
Y
Sleep Timer Select Sleep Timer from the Main Menu to turn off the SC-30d/SC-35d after a specified
interval. Press or to select Off, 30 Minutes, 60 Minutes, 90 Minutes, 2 Hours or
4 Hours. Then, press ENTER.
Information Signal / System: Select Information from the Main Menu, then choose either Signal or
System to display information about the current input signal (resolution, frequency, type et
cetera) and installed firmware versions, as well as other information that uniquely identifies
your Dimension Digital Controller and display device.
Should you ever need to contact Runco Technical Support, this information will help them
answer your questions or resolve product performance issues.
Network: Select Information from the Main Menu, then choose Network to display
information about the Ethernet network connection.
To enable network communication via Ethernet, refer to IP Configuration on page 90.
Field Service / Manufacturing: The Field Service and Manufacturing menus are
password-protected and intended for use only by Runco service personnel and factory
technicians.
Sleep Timer
Î
Off
30 Minutes
60 Minutes
90 Minutes
2Hours
4Hours
➤
Information
Signal
System
Network
Field Service
Manufacturing
➤
Signal
Input Source HDMI 1
Signal Format 1080p/60
Input Resolution 1920x1080
Vertical Freq 59.94 Hz
Horizontal Freq 67.500 kHz
Pixel Clock 148.500 MHz
Color Space REC709
Sync Type Separate
3D Mode Side-by-Side
Memory Preset ISF Night
System
Model DC-300
Display Name SC-30d/SC-35d
Output Resolution 1920x1080
Serial Number 00000000
Boot Version 1.0
Firmware Version 1.5
Micro Version 1.2
Input FPGA Version 1.0
Output FPGA Version 1.0
Network
MAC Address 1A:2B:3C:4D:5E:6F
IP Address 192.168.0.150
Subnet Mask 255.255.0.0
Default Gateway 192.168.1.1
DHCP Enabled
Network Status Connected