Filter
Top Products
System Overview
Runco SC-30d/SC-35d Installation/Operation Manual 17
PRE
L
IMINAR
Y
14. 3D Mode Selection Buttons:
3D AUTO
Press to set the 3D Mode to Auto.
3D SBS (Side-by-Side)
Press to set the 3D Mode to 3D Side-by-Side.
3D TAB (Top-and-Bottom)
Press to set the 3D Mode to 3D Top-and-Bottom.
3D FP (Frame Packing)
Press to set the 3D Mode to 3D Frame Packing.
2.5
SC-30d/SC-35d Active
3D Emitter
The Active 3D Emitter, shown below, receives a left/right synchronization signal from the
Dimension Digital Controller and transmits it to the Active 3D Glasses worn by the viewers.
This signal precisely controls when left and right fields are visible through the glasses.
The Active 3D Emitter has the following
functional components:
1. LED Indicators
Five (5), multi-colored LEDs indicate
modes of operation. During normal
operation, all five LEDs are off.
2. Joystick
Use this to enable various modes and
change settings.
3. USB Port
A USB “Micro B“ port for connecting
to a PC to perform software upgrades.
4. 3D SYNC IN
Connect the 3D SYNC output from
the Dimension Digital Controller (see
Figure 2-5) to this input, using the
supplied cable.
For more information configuring the emitter to work with the 3D glasses, refer to Using
the 3D Glasses on page 98.
For more information about 3D modes, refer to 3D Mode on
page 75.
Note
3
1
2
4