Filter
Top Products
Operation
Runco SC-30d/SC-35d Installation/Operation Manual 93
PRE
L
IMINAR
Y
• Periodic Service Notification: You can have the Dimension Digital Controller send
periodic reminders via e-mail to perform regular maintenance tasks. To do this:
1. Select Periodic Service Notification from the E-Mail Notification menu.
2. Highlight Enable and press ENTER.
3. Highlight On and press ENTER.
4. Press MENU.
5. Highlight Timer and press ENTER.
6. Press or to set the notification interval in months. The range is from 1 to
255 inclusive; the default is 12 months.
7. Press MENU.
• Lamp Life Notification: To have the Dimension Digital Controller send a message
to the destination e-mail address when the lamp hour counter reaches a certain
threshold, select Lamp Life Notification from the E-Mail Notification menu. Then:
1. Highlight Enable and press ENTER.
2. Highlight On and press ENTER.
3. Press MENU.
4. Highlight Lamp Hours and press ENTER.
5. Press or to set the notification threshold in hours. The range is from 100 to
10,000 hours; the default is 1,000 hours.
6. Press MENU.
• Customer Information: Select Customer Information from the E-Mail Notification
menu to supply this information to the Dimension Digital Controller, which includes it
in all e-mail notification messages. Six lines (up to 30 characters per line) of text are
provided; use them however you wish.
1. Press or repeatedly to select a line of text to edit.
2. Press ENTER.
3. Press or repeatedly to set the highlighted character.
4. Press (or ) to select the next (or previous) character. Use the and
buttons to change it.
5. Press ENTER when you have finished editing that line of text.
6. Repeat Steps 1 through 5 for each line of text you want to edit.
7. Press MENU when you have finished entering customer information.
• E-Mail Calibration Data: To have the Dimension Digital Controller collect all
calibration data, attach it to a message and send it to the destination e-mail address,
select E-Mail Calibration Data from the E-Mail Notification menu. To confirm this
action, select Yes and press ENTER.
To cancel and return to the previous menu, select No.