Filter
Top Products
Operation
86 Runco SC-30d/SC-35d Installation/Operation Manual
PRE
L
IMINAR
Y
Press MENU to exit test pattern mode.
Grey Bars
Use this pattern when making
brightness, contrast or white
balance (gain/offset) adjustments.
Full White
Use this pattern when measuring
or adjusting brightness, contrast or
white balance (gain/offset).
Primary Alignment
Secondary
Alignment
Dual Alignment
Use this pattern when aligning the
output from the projector’s
primary or secondary optical
engines (refer to Adjusting the
Image Geometry on page 53).
Select Dual Alignment to have
both optical engines output this
pattern.
3D
Use these patterns to confirm that
the left-eye and right eye images
are being processed correctly. To
do this, close your right eye while
viewing this test pattern through
the 3D glasses. If you see only the
left-eye portion, then the system is
correctly configured for 3D.
Normally, the Primary scaler
processes the left-eye image; the
Secondary, the right-eye image.
To change this, use the Reverse
Eyes control in the 3D Processing
menu (refer to Reverse Eyes on
page 75).
Table 4-4. Test Patterns and Their Suggested Usage (continued)
Pattern Suggested Usage