Filter
Top Products
Installation
20 Runco SC-30d/SC-35d Installation/Operation Manual
PRE
L
IMINAR
Y
3.2
Quick Setup
Table 3-1 gives a quick overview of the SC-30d/SC-35d installation process. The sections
following this one provide detailed instructions.
Table 3-1. Installation Overview
Step Procedure
For Details, Refer
to page...
1
Choose a location for the projector 21
2
Install primary projection lens 28
3
Install anamorphic lens mounting assembly (optional) 30, 40
4
Mount the projector 34
5
Mount the Dimension Digital Controller 35
6
Connect the Dimension Digital Controller to the projector 36
7
Connect other external equipment to Dimension Digital Controller
(optional):
• Audio processor or secondary display device
• Control system interface (RS-232)
• 12-volt trigger-activated equipment (retractable screens or
screen masking)
• External IR repeater
• Network hub, router or gateway (Ethernet)
38
8
Connect signal sources to the Dimension Digital Controller 43
9
Connect the Active 3D Emitter to the Dimension Digital Controller 49
10
Connect system components to AC power 49
11
Apply power to the projector 50
12
Adjust primary lens: projected image size (zoom), position (shift)
and focus
24, 51
13
For rear-screen and/or ceiling-mount installations, select the
proper picture orientation
52
14
Use Image Alignment controls to fine-tune image geometry 53
15
Install and adjust secondary anamorphic lens (optional) 55
16
Display calibration: adjust the following for each Dimension
Digital Controller input and display mode (resolution/frame
rate); save settings when finished:
• Aspect ratio • Color level
• Brightness • Tint
• Contrast • Input position
• Color temperature and white balance
64 through 83
17
Prepare Active 3D Glasses for use and test with 3D source mate-
rial
98