Filter
Top Products
Installation
Runco SC-30d/SC-35d Installation/Operation Manual 59
PRE
L
IMINAR
Y
Yaw Adjust: Loosen the Yaw/X-Adjustment Levers to allow the lens to pivot freely from
side to side. Then, angle the lens to even out any left-to-right pincushion distortion:
Once the proper lens angle has been set, firmly tighten the Yaw/X-Adjustment Levers to
secure the lens in place.
Geometry:
1. Unscrew the Anamorphic Lens just enough to allow it to rotate freely.
2. Grasp the lens by the center ring and rotate the lens until the image is properly
anamorphic:
3. When the image geometry appears correct, tighten the
Anamorphic Lens Set Screw (3) to secure the lens in place. (When
viewed from the front, the rear opening on the anamorphic lens
should appear as a tall, narrow oval.)
Focus: Finally, rotate the Focus Ring on the anamorphic
lens to fine-tune the optical focus.
Anamorphic Lens (Top View)
Wrong Position Correct Position
F
O
C
U
S