Filter
Top Products
Operation
96 Runco SC-30d/SC-35d Installation/Operation Manual
PRE
L
IMINAR
Y
HDMI: Select HDMI from the Service menu to set the following options affecting
communication between HDMI sources, the Dimension Digital Controller and the
SC-30d/SC-35d.
• HDMI EDID Extension: Extended display identification data (EDID) is a data structure
provided by a display device to describe its capabilities to a graphics card. It is what
enables a modern personal computer to know what kind of monitor is connected.
Some modern display devices provide more information via EDID than others, in the
form of “extensions.” Some computer graphics cards do not recognize or properly
interpret this extended EDID information.
Select HDMI EDID Extension from the HDMI menu to specify whether or not the EDID
extensions from the display device are passed through to the sources connected to the
HDMI and/or DisplayPort inputs. By default, the extensions are on. Change these
settings only if HDMI EDID incompatibility issues arise.
•Audio Format: Select Audio Format from the HDMI menu to choose an option for
routing the audio signal from an HDMI source. With the SC-30d/SC-35d, the
recommended setting is HDMI Out (Audio Only). (This is also the default setting.)
•CEC: This control chooses whether or not the Dimension Digital Controller responds to
HDMI CEC control messages from a disc player, set-top box or other HDMI source.
The default setting is On. For more information about CEC, refer to Using HDMI CEC
Messages on page 127.
• HPD Toggle Rejection: Select HPD Toggle Rejection from the HDMI menu to specify
whether or not the Dimension Digital Controller ignores extraneous Hot Plug Detect
(HPD) signal state changes from a downstream HDMI device (third-party display or
audio/video receiver).
The default setting, Auto, disables HPD toggle rejection on the SC-30d/SC-35d. Use
the other settings to troubleshoot compatibility issues or reduce the amount of time
needed to lock to an incoming signal.
Front Panel Brightness: Select Front Panel Brightness from the Service menu to adjust
the brightness of the front-panel LED and LCD status indicators.
The Dimension Digital Controller does not transmit HDMI CEC
control messages from the “HDMI Audio Out” connector,
regardless of the CEC setting.
Note
Logo LED
LCD
Standby LED