Filter
Top Products
Operation
88 Runco SC-30d/SC-35d Installation/Operation Manual
PRE
L
IMINAR
Y
When you change the Remote Code on the Dimension Digital Controller, you must
re-program the Dimension Digital Controller remote control to send that same code. To
enable “extended” key code mode, you must re-program the Dimension Digital
Controller remote control with a special five-digit code reserved for that purpose.
To do this:
1. Press and hold the LIGHT button on the
remote control for approximately five seconds,
or until the LED on the remote lights solid red.
2. Enter a new five-digit code between 00000 and
65535 inclusive;
— OR —
To enable extended key code mode, enter 88999. This mode allows certain
buttons to perform alternate functions; refer to SC-30d/SC-35d Remote Control
Unit on page 13. (To switch from extended mode back to standard mode, enter
any valid code other than 88999.)
Include leading zeros for codes with four or fewer digits; for example, enter 255 as
00255.
3. The LED turns off to confirm the code change. If you enter an invalid code, the LED
flashes for three or four seconds. Try again, entering a valid code.
For more information on using standard and extended remote control key codes, refer
to Using Discrete IR Codes on page 122.
• SRC 1-7 Keys / SRC 8-14 Keys: Select SRC 1-7 Keys or SRC 8-14 Keys from the
Remote Control menu to assign the source selection buttons to the source inputs on
the Dimension Digital Controller (refer to SRC 1, SRC 2 ... SRC 14 on page 16). By
default, these buttons are assigned as follows:
Remote Control Button Default Source Assignment
SRC 1 ... SRC 8
HDMI 1 ... HDMI 8
SRC 9
DisplayPort
SRC 10
Component
SRC 11
HD 1
SRC 12
HD 2
SRC 13
Composite 1
SRC 14
Composite 2