Filter
Top Products
System Overview
Runco SC-30d/SC-35d Installation/Operation Manual 9
PRE
L
IMINAR
Y
2.3
DC-300 Dimension
Digital Controller
The Dimension Digital Controller provides “left-eye” and “right-eye” video signals and the
OSD menu to the projector. It controls the other system components in response to user
input via the following interfaces:
• Front-panel keypad
• IR remote control unit
• HDMI CEC messages
• Serial commands via RS-232 or TCP/IP
•Ethernet
Front Panel LayoutFigure 2-4 shows the controls and indicators on the Dimension Digital Controller front
panel; the paragraphs that follow describe them.
Figure 2-4. Dimension Digital Controller Front Panel
1. RUNCO ICON
Lights blue to indicate that the controller is on or powering up.
2. IR SENSOR
Receives IR commands from the remote control.
3. VACUUM FLUORESCENT DISPLAY
Can be used instead of the On-Screen Display (OSD). Displays currently-selected
menu or – if no menu is selected – the connected display device model, current
source, input resolution and aspect ratio/screen.
4. ON/STANDBY BUTTON
Press once to toggle from standby mode to on mode. Press it again to return to
standby mode. For a discrete on or off command, you can use the direct access
buttons on the remote control.
5. LEFT BUTTON
Used to direct-select inputs or move the menu cursor left in the OSD. When no menu
is present on-screen, the LEFT button toggles through the different sources, in this
order:
DisplayPort - HDMI 8 - HDMI 7 - HDMI 6 - HDMI 5 - HDMI 4 - HDMI 3 - HDMI 2 -
HDMI 1 - SCART - HD 2 - HD 1 - Component - Composite 3 - Composite 2 -
Composite 1
r
a
t
i
o
r
a
t
i
o
i
n
p
u
t
standby
m
e
n
u
i
n
p
u
t
e
n
t
e
r
HDMI 1
16:9/1 1080i/60
3
1
91011
654 87
2
SC-30d/SC-35d