Filter
Top Products
System Overview
14 Runco SC-30d/SC-35d Installation/Operation Manual
PRE
L
IMINAR
Y
1. IR OUTPUT INDICATOR
Lights when a button is pressed to indicate that an IR signal is being transmitted.
2. OFF (Standard) / S leep Timer = 30 Minutes (Extended)
Press to turn off the Dimension Digital Controller and projector. In extended mode,
press to set the Sleep Timer to 30 minutes.
3. ON (Standard) / Sleep Timer = Off (Extended)
Press to turn on the Dimension Digital Controller and projector. In extended mode,
press to disable the Sleep Timer.
4. Aspect Ratio Selection Buttons
Use these buttons to select an aspect ratio directly, as follows:
16:9 (Standard) / Sleep Timer = 60 Minutes (Extended)
For viewing 16:9 DVDs or HDTV programs in their native aspect ratio. In extended
mode, press to set the Sleep Timer to 60 minutes.
4:3 (Standard) / Sleep Timer = 90 Minutes (Extended)
Scales the input signal to fit 4:3 display mode in the center of the screen. In extended
mode, press to set the Sleep Timer to 90 minutes.
LETBOX (Letterbox - Standard) / Sleep Timer = 2 Hours (Extended)
For viewing non-anamorphic (“full-screen”) DVDs on a 16:9 screen. In extended
mode, press to set the Sleep Timer to 2 hours.
V-WIDE (VirtualWide - Standard) / Sleep Timer = 4 Hours (Extended)
Enlarges a 4:3 image horizontally in a non-linear fashion to fit 16:9 full screen display.
In extended mode, press to set the Sleep Timer to 4 hours.
CINEMA (Standard) / Video 1 Input (Extended)
For viewing 2.35:1 source material. In extended mode, press to select the Video 1
(Composite 1) input.
V-CINE (Standard) / Component Input (Extended)
Selects the Virtual Cinema aspect ratio, used for viewing 16:9 source material on a
2.35:1 screen. In extended mode, press to select the Component input.
NATIVE (Standard) / HD 1 Input (Extended)
Displays the source signal in its native resolution, centered in the display area. In
extended mode, press to select the HD 1 input.