Filter
Top Products
Operation
94 Runco SC-30d/SC-35d Installation/Operation Manual
PRE
L
IMINAR
Y
• Remote Network Control: Select Remote Network Control from the Network menu
to enable or disable control of the Dimension Digital Controller via an IP connection
(typically using a web browser). Set it to On to allow all incoming remote network
connectivity. Set it to Off to disable any incoming network communication that was not
initiated by the Dimension Digital Controller.
Color Space: Select Color Space from the Service menu to choose the color space of
the source signal for HDMI, RGB, and component connections.
• The default setting, Auto, functions as follows:
• HDMI: If the Auxiliary Video Information (AVI) infoframe contains color space and/or
range data, the Dimension Digital Controller uses that information. Otherwise, for
RGB sources, the Dimension Digital Controller uses the RGB-Video color space.
For component SDTV and EDTV resolutions, REC601 is used. For other component
video resolutions, REC709 is used.
• RGB: If Hsync or Vsync signals are present, the Dimension Digital Controller uses
the RGB-PC color space. Otherwise, REC601 is used for SDTV and EDTV sources,
and REC709 for all other sources.
• Component: For SDTV and EDTV resolutions, the Dimension Digital Controller uses
the REC601 color space. For all other resolutions, REC709 is used.
In most cases, the Auto setting determines the correct color space to use. If it does not,
you can force the Dimension Digital Controller to use a specific color space. Choose one
of the following:
• REC709 sets the color space matrix to that defined in ITU-R BT.709.
• REC601 sets the color space matrix to that defined in ITU-R BT.601.
• RGB-PC uses RGB color space and sets black at 0,0,0 RGB and white at
255,255,255 RGB, assuming an 8-bit image.
• RGB-Video uses RGB color space and sets black at 16,16,16 RGB and white at
235,235,235, assuming an 8-bit image, to correspond to the luminance values defined
in digital component standards.
Triggers: Select Triggers from the Service menu to configure the 12-volt trigger outputs.
You can assign one or more trigger outputs to each aspect ratio. Those triggers are then
activated by selecting that aspect ratio.
This setting has no effect on the E-Mail Notification or Auto
Firmware Upgrade functions.
Note