Filter
Top Products
RS-232 Settings
To configure the RS-232 settings:
1. From the Baud Rate drop‑down list, select the appropriate baud rate.
2. From the Stop Bits drop‑down list, select the number of bits used to indicate a
byte.
3. From the Bits drop‑down list, select the number of data bits to transmit.
4. From the Parity drop‑down list, select the parity checking type.
5. Click Save
Ethernet Settings
NOTE: The default setting is DHCP set to OFF, IP address = 192.168.254.254.
To configure the Ethernet settings for use with DHCP:
1. In the Ethernet Settings section, select the Use DHCPcheck box.
2. Click Save. Depending on your IT administrator, an IP address is automatically
assigned to the device.
To configure the Ethernet settings with a static IP address:
1. In the IP Address field, enter an IP address for the device.
2. In the Subnet Mask field, enter the subnet mask for the device.
3. In the Default Gateway field, enter the default gateway to be used.
4. Click Save.
Firmware Loader Page
This page allows the user to update the device firmware.
Click on this button
to open the page.
Figure 49. Firmware Loader Page
DVS 605 • Using the Default Web Pages 85