Extron electronic DVS 605 Stereo System User Manual


 
Resetting the Unit
There are three unit reset modes (numbered 1, 4, and 5), These are available by pressing
the recessed Reset button on the rear panel with a pointed stylus, pen, or similar item to
access it. See the following table for a summary of the reset modes.
ATTENTION: Review the reset modes carefully. Using the wrong reset mode may
result in unintended loss of flash memory programming, port reassignment, or
processor reboot.
NOTE: The reset modes listed closes all open IP and Telnet connections and all
sockets. Each mode is a separate function, and not a continuation from mode 1
to mode 5.
DVS 605 Reset Mode Summary
Mode Activation Result Purpose and Notes
Use Factory Firmware
1
Hold down the recessed Reset
button while applying power to the
unit.
The unit reverts to the factory default
firmware:
a) Reverts to the factory default firmware
for a single power cycle.
b) All user files and settings (drivers, audio
and video adjustments, IP settings, etc.)
are maintained.
Use mode 1 to revert to the factory
default version if incompatibility
issues arise with user‑loaded
firmware.
NOTE: After a mode 1 reset
is performed, update the
firmware of the unit to the
latest version. Do not operate
the device firmware version
that results from the mode 1
reset. This temporarily resets
the unit to factory default until
power is recycled. If you want
to use the factory default
firmware, you must upload
that version again.
NOTE: If you do not want to update
firmware, or you performed a mode 1
reset by mistake, cycle power to the
unit to return to the firmware version
that was running prior to the mode
1 reset. Use the 0Q SIS command
to confirm that the factory default
firmware is no longer running (look for
asterisks following the version number).
Reset All IP
Settings
4
Hold down the Reset button for
about 6 seconds until the LED blinks
twice (once at 3 seconds, once at 6
seconds). Then, release and press
Reset momentarily (for <1 second)
within 1 second*.
a) Sets port mapping back to factory default
b) Turns DHCP off ‑ sets IP to default address
(192.168.254.254)
c) Reset LED flashes four times in quick
succession during reset.
Mode 4 resets all IP settngs back
to factory defaults.
Reset to Factory Defaults
5
Hold down the Reset button for
about 9 seconds until the LED blinks
three times (once at 3 seconds, once
at 6 seconds, once at 9 seconds).
Then, release and press Reset
momentarily (for <1 second) within 1
second*.
Mode 5 performs a complete reset to factory
defaults except the firmware.
a) Does everything mode 4 does.
b) Resets all user modifiable configuration to
default values including IP settings and
real‑time adjustments.
c) Deletes all user loaded files.
d) The Reset LED flashes 4 times in quick
succession during the reset.
Mode 5 is useful if you want to
restart with default configuration.
Equivalent to SIS command ZQQQ.
NOTE: *For modes 4 and 5, nothing happens if the momentary press does not occur within 1 second
Figure 25. Reset Mode Comparison
DVS 605 • Operation 33