Filter
Top Products
Advanced Configuration
The following flowchart provides an overview of the Advanced Configuration submenu
The options are Auto‑Image (on or off), aspect ratio (fill or follow), auto memory (on or off),
overscan (none, 2.5%, and 5.0%), switch type (dissolve or cut), test patterns (see table on
page 25), OSD duration, temperature (device reading only) and factory reset.
ADVANCED
CONFIG
AUTO IMAGE
IN#x Off
Rotate either to
turn Auto Image
mode on or off.
TEST PATTERN
COLOR BARS
Rotate either to
change test pattern.
TEMPERATURE
96 F 35 C
FACT. RESET
HOLD AUTO
Indicates internal temperature
(not adjustable).
Press and hold Auto button
to reset unit to factory settings.
SWITCH TYPE
DISSOLVE
Rotate either to
change switch
type.
AUTO MEMORY
IN#x ON
Rotate either to
turn auto memory
on or off.
ASPECT RATIO
IN#x FILL
Rotate either to select
aspect ratio mode.
OVERSCAN
S-VIDEO 5.0%
Rotate either to set
overscan value.
Next
Next
Next
Next
Next
Next
Next
Next
OSD DURATION
125 SEC
Rotate either to
set OSD duration.
Next
Figure 18. Advanced Configuration Menu
Aspect Ratio
Use either Adjust knob ([ {) to set the aspect ratio to Fill or Follow.
The aspect ratio setting is per input, and allows the user to select between each input
signal filling the entire output raster (Fill ‑ default setting), or for each input rate to be
displayed with its native aspect ratio (Follow ‑ 4:3, 5:4, 15:9, 16:9, 16:10) with the correct
letter box or pillar box settings visible under the Image Size and Image Position Picture
Controls.
When in the Fill mode, if an aspect ratio adjustment for a single input rate is desired, the
correct size and center can be set up using Image Size and Image Position under Picture
Controls, using one of the aspect ratio test patterns for a template. If auto memory is
enabled, then these settings are saved and recalled the next time the signal is detected.
The DVS 605 clears the previous size and position settings whenever the aspect ratio
setting for an input is adjusted.
NOTE: Unique SIS commands can set the device to Auto‑Image and Fill or
Auto‑Image and Follow, regardless of the current aspect ratio.
DVS 605 • Operation 23