Filter
Top Products
Powering Up
When applying power to the DVS 605, the unit undergoes a start‑up self testing sequence
(see image below) and then the LCD displays the default display cycle.
Default Display Cycle
When in use but not in any menu mode, the LCD screen defaults to cycling through the
input/output configuration currently installed. The displayed content may vary, depending
on the input video signal type. See figure 8 for a typical default display cycle.
Figure 8. Typical Default Display Cycle
The default display cycle shows the scaler output rate and refresh rates for the currently
selected input.
The DVS 605 Menu System — Configuration and Adjustments
Scaler configuration and adjustments can be performed by using the embedded web
pages (see “Using Default Web Pages” starting on page 60 ), the Extron Simple
Instruction Set (SIS) of commands (see “SIS Communication and Control” starting on
page 34), or by using the front panel controls and the menus displayed on the DVS unit’s
LCD screen. These menus are used primarily when the scaler is first set up.
Menu Navigation Using Front Panel Controls
Menu button — Press the Menu button to activate menus and scroll through the eight
main menus.
Next button — Press the Next button to move between the submenus of a selected
main menu item.
Adjust ([,{) knobs — In configuration mode, rotate the Adjust horizontal ([) knob
and Adjust vertical ({) knob to scroll through submenu options and to make adjustment
selections. See the flowcharts in this chapter for explanations on knob adjustments.
DVS 605 • Operation 13