Filter
Top Products
Temperature
This is a read‑only menu that gives the internal temperature (degrees C and F) of the
connected device. No adjustments can be made.
Factory Reset
This menu allows the user to reset the device to the factory default settings.
Press and hold the Auto‑Image button until the display changes. Release and press
Auto‑Image again to confirm that a reset is desired. The device will be reset.
View Comm Settings
The current RS‑232 and IP settings are read‑only with this menu. To make any setting
adjustments, the “hidden” Edit Comm Settings menu must be accessed (see below).
Press Next to go through each sublevel to view the following: serial port (baud rate and
communication type), MAC address (cannot be changed), DHCP status (on or off),
IP address, subnet mask, and gateway address.
NOTE: To enter the “hidden” Edit Comms Settings menu, press and hold in the input
5 and Next buttons simultaneously. The Edit Comms Settings menu appears.
SERIAL PORT
9600 RS232
EDIT COMM
SETTINGS
Rotate to
change baud rate.
DHCP MODE
<On>
Rotate either to
turn DHCP mode
On or Off.
Rotate to select
octet field. Rotate
to change IP address.
Rotate to select
octet field. Rotate
to change subnet
mask address.
Rotate to select
octet field. Rotate
to change gateway
address.
“Hidden” Menu
S 255.255
M 000.000
G 192.168
W 000.000
Next
Next
I 192.168
P 254.254
Next
Next
Next
Next
Figure 21. Edit Comm Settings Menu
Exit Menu
From this submenu, press the Menu button to return to the User Presets menu cycle, or
press the Next button to exit the menu and return to the default cycle.
DVS 605 • Operation 26