Filter
Top Products
79
Chapter 3 Menu
Chapter 3 Menu
A MODE button
B PRESET button
C START button
D SAME AS TIME button
E STOP button
F PRESET/GENERATE
TIME display window
A MEASURE selector
B TEMPO display window
C OFFSET display window
6 MEASURE/TEMPO section
When the BARS button is lit on the timecode input
section on the Automation panel, the beats and bars
are calculated on the settings entered in this section.
7 TIME CODE GENERATOR section
A MODE button
Touch this button to set the operation mode of the
built-in timecode generator.
• LOCAL
The timecode can be run and stopped using the
START/STOP buttons.
• SLAVE LOCK
Generates the timecode based on the timecode read
by the built-in reader.
• SLAVE LOCK (AUTO RUN)
Once the timecode read by the built-in reader runs
correctly, the timecode is generated as running
automatically generated regardless of the incoming
timecode.
• EMULATE MTR
Controls using the machine control functions of the
unit as the emulation machine. In this mode, a
LOCATE command will produce a burst or timecode,
allowing the machine using the timecode chase to
locate.
A MEASURE selector
Selects the measures of a tune.
First level: n/2, n/4, n/8, n/16
2nd level: n
B TEMPO display window
Touch this part to select and enter the tempo.
C OFFSET display window
Touch this part to select and enter the timecode of the
first beat of the first measure.
Notes
• The values of the measure, beats and MIDI clocks
displayed when pressing the BARS button on the
Automation panel are estimated values obtained by
converting the timecode value based on the
information set by MEASURE/TEMPO section. The
greater the difference from the timecode set on the
OFFSET display window is, the greater the error is.
• The automation operation is executed based on the
timecode regardless of the setting of the BARS
button.
G USER’S BIT display
window