Sony DMX-R100 Stereo Amplifier User Manual


 
55
Chapter 3 Menu
Chapter 3 Menu
AUDIO INPUT ROUTING Window
To open this window, touch the AUDIO button on the
bottom menu bar, then select INPUT ROUTING.
This window allows you to assign the desired input
signal to the desired channel.
2 V button
2 v button
Block list
TB IN button
1 Destination select buttons
3 Source select button
4 DEFAULT button
1 Destination select buttons (CH-1 to CH-48, AUX
RET 1 to 8, INS RET 1 to 8, EXT MONI 1 to 6, TB
IN)
The large display area shows all of the available
destinations for the input matrix. Once an input signal
has been selected, routing is achieved by pressing the
appropriate destination button.
The talkback microphone can also be routed.
By selecting the TB IN button, the input signal selected
by the source select button is used as the talkback
signal. For example, if you assign LINE IN CH24 to
the TB IN button, the input of the LINE IN CH 24 can
be used as the talkback signal.
2 v/V buttons
Touch the V button to select the block over the
currently selected block.
Touch the v button to select the block below the
selected block.
3 Source select button
Displays the selected source block.
Touch this button to open the block list in the B
direction. Touch the desired block button to open the
list of the sources included in the block.
The list of source blocks and the source list of each
source block are as follows:
Blocks for AD 1 to 8 to AD 17 to 24
Each block has the source lists for 8 inputs.
Blocks for SLOT 1 to SLOT 4
Each block has the source lists for 8 channels.
AUX RET block
This block has the source list for 8 channels.
MISC block
Includes the lists of 2TR1-L, 2TR1-R, 2TR2-L,
2TR2-R, NC (NO CONNECTION) and TB MIC.