Sony DMX-R100 Stereo Amplifier User Manual


 
100
Chaper 4 Operation Tips
Chapter 4 Operation Tips
Basic Operation Procedure
8 Drop out the automation data using one of the following methods.
Touch the MASTER DROP IN button on the window to turn its color
to dark red.
Touch the numerical value of the items subject to automation.
Release the fader.
Stop the tape recorder.
Automation data for the items set in WRITE mode in step 6 is written.
Notes
If a lot of items are dropped in/out at the same time using the MASTER
DROP IN button, data near the drop in/drop out point may not be stored
and recalled correctly.
Automation items in WRITE mode are removed from snapshot recall and
control from MIDI.
Updating automation data
The data of the automation items is recalled according to the timecode
entered. To update automation data, set the desired automation items to
READY, then drop them into WRITE.
You can select either ABS mode or TRIM mode to update data, using the
ABS button or TRIM button of the TC AUTOMATION buttons on the
Automation panel.
In ABS mode, you can set the speed to return to the previous data from the
new data in the AUTO RETURN TIME section in the AUTOMATION
window.
Manupulating
the fader
Data stored the last time
Data stored the last time
The operation performed while holding the fader
down is added to the last stored data as offset and
recalling is continued.
The following figures show the fader operation and the results
of the fader operation.
Fader operation and its results
In the figures, the fader operations are indicated using the
following lines:
: Indicates the data stored last time (previous data)
: Indicates the actual resuts of the fader operation
(new data).
When operating the faders in ABS mode
When operating the faders in trim mode
BUTT: The fader is reset to the
position stored the last time
(previous data) at the instant you
release the fader.
RAMP: The fader is reset to the
stored position at the specified
speed, when you release the
fader.
HOLD TO NEXT: After you release
the fader, the faders position
remains as it is up to the next
event.
HOLD TO END: After you release
the fader, the faders position
remains as it is up to the end.
The previous data is overwritten.
Manupulating
the fader