Filter
Top Products
RC3000 Antenna Controller Chapter 3 Detailed Operation
84
3.2.2.4 Store
The STORE mode saves a satellite’s name, azimuth and elevation positions, horizontal and vertical
polarization positions and RF band in memory for use in later RECALLing the satellite.
When the STORE mode is entered, it is assumed that the user has peaked up on the satellite. The first
screen that appears asks the user to confirm the name of the satellite to be stored. The name displayed
is that of the latest satellite “selected” in LOCATE mode.
SAT LON INCLIN BAND STORE
BRASIL A1 79.0 2 C
VERIFY SATELLITE DATA OK FOR STORING
<1>CORRECT <2>INCORRECT <MODE>EXIT
If this is not the correct satellite (<2>), the following message will be displayed on lines 3 & 4 to remind
the user to “select” the correct satellite from the LOCATE mode.
GO TO LOCATE MODE TO SELECT SATELLITE
<MODE> RETURN TO MENU
If the satellite data is correct(<1>), the user will next be asked to store values for horizontal and vertical
polarization positions. While this screen is displayed, the Pol CW and Pol CCW keys are active allowing
the user to peak up in this axis. The “5” key is also active to initiate a 90 degree “cross polarization”
movement. Note that the user will need to tune the receiving equipment to correct frequencies for the
different polarizations. To store a polarization position, press the H key for horizontal and V for vertical.
When a polarization is stored, the display for that orientation will change from “NOT SET” to SET.
HORIZONTAL: NOT SET STORE
VERTICAL: NOT SET
POL: -4.3 SS1:795 L
<5>X-POL <POL CW/CCW>PEAK <H/V>STORE POL
Note that if the signal strength source is not correct to peak up on, go to the MANUAL mode to change
signal strength source.
If the selected satellite is not inclined, the following screen will appear momentarily and the RC3000 will
return to MANUAL mode.
*** SATELLITE DATA STORED ***
RETURNING TO MANUAL MODE
RECALL SATELLITE VIA MENU-RECALL
If an inclined satellite is selected (and the inclined orbit tracking option is present), control will
automatically move to the TRACK (3.2.2.9) mode.
If the STORE function is completed correctly, the mount’s position will saved (see POSITION 3.2.2.7). If
the position is saved, the user will be asked to verify the position upon power up of the RC3000. If the
mount has moved, STORED’d data will no longer be valid since the azimuth and elevation angles will no
longer be correct.