Filter
Top Products
24
Chapter 1 Overview
f LAN connector A ( )
An Unshielded Twisted Pair (UTP) cable is plugged in. For 1000Mbps connection, a cable
conforming to category 5 enhanced is required.
As LAN connector A uses the Communication Streaming Architecture (CSA) port, its data
transfer speed may be higher than that of LAN connector B.
The meanings of the two LED are shown in the table below.
g LAN connector B ( )
This is a PCI port. The applicable cable and meanings of the LEDs are the same as those for LAN
connector A.
h USB connector ( )
Connects peripheral equipment conforming to the USB standard (2.0 or 1.1).
i Rear maintenance LED ( )
This LED lights or blinks in amber when an error is detected in the server components.
If this LED lights or blinks, contact an office listed in the "Contact Information" of "Start Guide".
j System identification LED ( )
This LED is used for maintenance. When pressing this button, the front and rear system
identification LEDs are lit blue so that the locations of devices being maintained can be
determined. Also, the [System Identification LED Display] button of ServerView can be used to
light them.
table: LAN connector LED
LED
location
LED status LAN Status
Left Lights green Link is being established.
Blinks green Data is being transferred.
Off Link is not established.
Right Lights amber Connection is established at
1000Mbps.
Lights green Connection is established at 100Mbps.
Off Connection is established at 10Mbps.
ID