Filter
Top Products
231
PRIMERGY RX100 S2 User’s Guide
9
Operation and Maintenance
■ Error Window Appearing after Installation or Uninstallation of
ServerView or RAID Management Tool (Global Array Manager) on
Windows Server 2003
Systems with Windows Server 2003 Service Pack 1 may display the following popup message at the
next startup after installation or uninstallation of ServerView or RAID Management Tool (Global Array
Manager). This is not a problem. Click [Close message] to close the message.
■ Error Messages during Installation
The following error messages may appear during installation using ServerStart. Check the corrective
action against the relevant error.
● "WzDiskAdmin: System Error! ......................... , Last Error: The device is not
ready."
Optional SCSI devices (e.g., hard disk cabinet or DAT unit) may be connected. Disconnect the optional
SCSI devices and perform installation again. Connect the optional devices after the installation
completes.
● "WzDiskAdmin: Partition detected! Please delete all partition before starting
Configuration"
Run the guide or preconfiguration mode again. Check [Delete all partitions on the displayed disk] in the
disk wizard.
● "WzRaid: RAID arrays detected! Please delete all RAID arrays before starting
Configuration"
Use the ServerStart floppy disk you have created. Check [Delete existing RAID array] or select [Use
existing array] in the RAID wizard.
● "Operating System not found" appears when the system restarts after file
copy from the CD-ROM.
The following are possible causes.
• The array controller card comes later than the onboard SCSI in order of device startup.
• The Active flag is specified.
● "Missing Operating System" appears during installation.
The installation partition size may be too large. Specify the installation partition size correctly.
For details on the installation partition size, refer to "2.3.1 Installation Partition Size" (
pg.44).
Windows has terminated the following program to prevent
damage to your computer. Name: SNMP Service