Filter
Top Products
121
PRIMERGY RX100 S2 User’s Guide
1
2
3
4
5
6
7
9
8
Manual OS Installation
• When a recognized network adapter is present
Perform "
■ Updating LAN Drivers" (pg.121) on the LAN device name under [Network
adapters], then "
■ Installing the LAN Driver" (pg.122) on [Ethernet controller] under [Other
devices].
When the LAN driver is installed to [Other devices] before updating the driver for
the network adapter recognized immediately after the OS installation
When driver installation starts, the following window appears.
Clicking [Finish] displays the [Help and Support Center] window. Click [X] to close the window.
After installation, the "!" mark is displayed at the LAN device name in Device Manager. Device
names are displayed properly when all LAN drivers are installed and the system is restarted.
• When a recognized network adapter is not present
Perform "
■ Installing the LAN Driver" (pg.122) on [Ethernet controller] under [Other
devices].
■ Updating LAN Drivers
Perform the following procedures on all LAN device names under [Network adapters] in [Device
Manager].
1 Double-click a LAN device name under [Network adapters].
Names of the LAN devices are displayed as follows.
2 Insert the driver disk created from the ServerStart CD-ROM into the server
according to the installed LAN device.
3 Double-click the LAN device icon.
The properties are displayed.
table: LAN device name
LAN cards LAN device name
PG-1852 Intel(R) PRO/1000 MT Desktop Adapter
PG-1862 Intel(R) PRO/1000 MT Dual Port Server Adapter