Filter
Top Products
23
PRIMERGY RX100 S2 User’s Guide
1
Overview
i System identification LED ( )
This LED is used for maintenance. When pressing this button, the front and rear system
identification LEDs are lit blue so that the locations of devices being maintained can be
determined. Also, the [System Identification LED Display] button of ServerView can be used to
light them.
j Hard disk access display LED ( )
This LED lights green when data is being written to or read from the hard disk.
k Front maintenance LED ( )
This LED lights or blinks in amber when an error is detected on the server components.
If this LED lights or blinks, contact an office listed in the "Contact Information" of "Start Guide".
l Power LED ( )
This LED is lit green when the server is turned on.
This is lit amber when the server is not turned on (standby mode).
This does not light when the power cable is unplugged from the outlet.
1.3.2 Server (Rear View)
a Inlet
AC power cables are plugged in.
b Keyboard connector (6 pin) ( )
A keyboard is plugged in.
c Mouse connector (6 pin) ( )
A mouse is plugged in.
d Serial port (9 pin) ( )
Cables of peripheral devices conforming to the RS-232C standard such as modems are plugged
in.
e Display connector (15 pin) ( )
A display cable is plugged in.
ID
abd
ij
c e f g h