Filter
Top Products
216
Chapter 8 Hardware Configuration/Utilities
8.2.16 Exit Menu
Exits BIOS Setup.
table: Items on the Exit Menu
Item Description
Save Changes & Exit Saves the current settings on the CMOS and exits the BIOS Setup Utility. The
server restarts at the same time.
Get Default Values Loads and displays the default settings for the server.
Note:
If you load the initial values and save the settings, the LAN settins for
remote operation using Remote Control Service is initialized. If you load
the initial values using this item and save them, configure the LAN setup
including IP addresses again.
Refer to "
■ LAN Settings Submenu" (pg.212) on the [IPMI] submenu
of [Server] menu.
"9.3.4 Before Using the Remote Control Service" (pg.242)
Discard Changes & Exit Exits the BIOS Setup Utility without saving current settings. Previously saved
settings remain valid.
Load Previous Values Loads and displays the settings that were enabled when the BIOS Setup Utility
started up.
Save Changes Save the settings on the CMOS.
Advanced Security Server
Save Changes & Exit
Get Default Values
Discard Changes & Exit
Load Previous Values
Save Changes
PhoenixBIOS Setup Utility
Item Specific Help
Main Exit
Execute Command
F1
Esc
Select Item
Select Menu
Change Values-/+
Enter
Info
Exit
F9
F10
Setup Defaults
Save and Exit