Filter
Top Products
223
PRIMERGY RX100 S2 User’s Guide
9
Operation and Maintenance
● Cannot write to the floppy disk.
The write protection of the floppy disk may be applied. Flip the switch on the disk to allow writing.
■ CD-ROM Drive Unit
● Cannot read data.
• Check to see whether the CD-ROM is inserted properly.
If it is not inserted, correctly insert the CD-ROM so that the label is facing up.
• Check to see whether the CD-ROM is not dirty.
If it is dirty, wipe it with a soft, dry cloth.
• Check to see whether the CD-ROM is not scratched or bent.
If scratched or damaged, replace the CD-ROM.
● The unit does not operate properly.
Check to see whether the internal cable is connected properly.
If it is not connected, correctly connect the internal cable. For the connection location, refer to "7.7
Connection of Optional Devices" (
pg.187).
■ Internal Hard Disk Units
● The unit does not operate properly.
Refer to "7.6 Installing an Internal Hard Disk Unit" (pg.180).
• Check to see whether the internal cable is connected properly. If it is not connected, correctly connect
the internal cable.
• Check to see whether the jumper pins are set properly. If they are not set, correctly set the jumper
pins.
■ System Fan
The server has six system fans. Contact an office listed in the "Contact Information" of "Start Guide"
when a system fan fails.
● The system fan cable has been disconnected.
Connect the cable as follows.
• If the fan cable is disconnected from the extension cable
Correctly connect a pair of cables of fans 1 and 2, a pair of cables of fans 3 and 4, and a pair of cables
of fans 6 and 7. Connect them according to the fan numbers indicated on the extension cable
connectors.