Filter
Top Products
Image Settings Page
From this page signal sampling and picture control settings can be set, user and input
presets can be saved and recalled, and overscan settings can be applied.
Click on this button
to open the Image Settings page.
Figure 48. Image Settings Page
Signal Sampling
In this section settings for the input signal of the currently selected input can be adjusted.
Adjustable fields are: the number of active lines, active pixels, total pixels, horizontal and
vertical start settings, and the pixel phase. In addition an Auto-Image (with Fill or Follow
modes) can be executed on the input.
In the Signal Sampling section, adjust an input signal setting by entering a value or clicking
the up > and down < arrows in the field associated with the setting. An asterisk beside a
chosen value for a signal sampling setting indicates that it is a default value for the applied
input signal.
An Auto-Image can also be executed on the current input. Auto-Image automatically
sizes and centers the selected input. If an unknown input is connected to the device, the
processor measures and estimates the resolution of the incoming video.
To perform an Auto-Image:
1. Click on the Auto-Image button. A drop-down list opens.
2. Select Auto-Image: with fill (to fill the entire video output) or
Auto-Image: with follow (to maintain the aspect ratio of the input).
See Auto-Image in the Input Configuration section, for steps to set automatic
activation.
DVS 605 • Using the Default Web Pages 73
73