Filter
Top Products
Powering Up
When applying power to the DVS 605, the unit undergoes a start-up self testing sequence
(see image below) and then the LCD displays the default display cycle.
Default Display Cycle
When in use but not in any menu mode, the LCD screen defaults to cycling through the
input/output configuration currently installed. The displayed content may vary, depending
on the input video signal type. See gure 8 for a typical default display cycle.
13
sec.
Apply
Power
EXTRON
DVS 605 XX
11
sec.
Last active input
button(s) remains lit.
16
sec.
60-1059-xx
FW v1.xx
All input LEDs flash
(red then green).
1 2 3
4 5 PIP
EXTRON
ELECTRONICS
1
2 sec.
2
sec.
Default Display Cycle
IN
RGBHV
#1 640x480
IN 31.47 kHz
#1 59.94 Hz
OUTPUT
720p@60
2 sec.
2
sec.
Display screen
first lights blank
Note: Times shown are approximate.
Figure 8. Typical default display cycle
The default display cycle shows the scaler output rate and refresh rates for the currently
selected input.
DVS 605 • Operation 12