Filter
Top Products
View Comm Settings
The current RS-232 and IP settings are read-only with this menu. To make any setting
adjustments, the “hidden” Edit Comm Settings menu must be accessed (see below).
Press Next to go through each sublevel to view the following: Serial port (baud rate and
communication type), MAC address (cannot be changed), DHCP status (on or off),
IP address, Subnet mask, and Gateway address.
NOTE: To enter the “hidden” Edit Comms Settings menu, press and hold in the input 5
and Next buttons simultaneously. The Edit Comms Settings menu appears.
SERIAL PORT
9600 RS232
EDIT COMM
SETTINGS
Rotate to
change baud rate.
DHCP MODE
<On>
Rotate either to
turn DHCP mode
On or Off.
Rotate to select
octet field. Rotate
to change IP address.
Rotate to select
octet field. Rotate
to change subnet
mask address.
Rotate to select
octet field. Rotate
to change gateway
address.
“Hidden” Menu
S 255.255
M 000.000
G 192.168
W 000.000
Next
Next
I 192.168
P 254.254
Next
Next
Next
Next
Figure 20. Edit Comm Settings Menu
Exit Menu
From this submenu, press the Menu button to return to the User Presets menu cycle, or
press the Next button to exit the menu and return to the default cycle.
Front Panel Lockout (Executive Modes)
To prevent accidental changes to settings, press the Menu and Next buttons
simultaneously for 2 seconds to enable front panel lockout mode (executive mode 2).
The menu system returns to the default menu within 10 seconds.
Executive mode 2 locks all front panel functions except input switching, PIP enable and
PIP swap, and Auto-Image. Menu and Next buttons and the Adjust knobs are disabled.
When executive mode 2 is active, all functions and adjustments can still be made through
USB, RS-232, or Ethernet control. For details on remote control, see “SIS Communications
and Control”.
To disable executive mode 2, press the Menu and Next buttons simultaneously for
2 seconds. See the owchart below.
Menu
Press both for
2 seconds
Next
EXEC. MODE 2
ENABLED
Enable Executive Mode
EXEC. MODE 2
DISABLED
Disable Executive Mode
Menu
Press both for
2 seconds
Next
2
sec.
I
n
R
G
BHV
#
1
640
x
480
In 31.47 kH
z
#1 59.94
Hz
O
utput
7
20p@6
0
3 sec.
timeout
3 sec.
timeout
Figure 21. Front Panel Lockout
Executive mode 1 locks all front panel functions completely. This mode can be enabled or
disabled by SIS commands only.
DVS 605 • Operation 23