Filter
Top Products
Command ASCII Command
(host to scaler)
Response
(scaler to host)
Additional Description
Genlock
Disable genlock
EOGLOK} Glok0]
Disables global input lock/genlock (default).
Enable input signal
genlock
E1GLOK} Glok1]
Locks the output refresh rate to the
selected input’s refresh rate.
Enable SDI genlock
E2GLOK} Glok2]
Locks the output refresh rate applied
genlock signal (D models only).
View genlock
setting
EGLOK}
X4&]
View the current genlock setting.
View genlock status
E41STAT}
X4*]
41Stat•X4*]
View the current genlock status.
(verbose mode response)
Video signal presence
View signal presence
0LS
}
X4$*X4$*X4$*X4$*X4$]
Input 1*2*3*4*5. (X4$; 0 = no input, 1 =
input detected)
Hardwired IR port
Disable IR disable
(allows IR)
65*0# IRDisable0]
Enables the hard wired port and allows IR.
Enable IR disable
(blocks IR)
65*1# IRDisable1]
Disables the hard wired port (default).
View IR disable
setting
65#
X(]
View the current IR Disable setting.
Picture In Picture
NOTE: HDMI input 5 cannot be used for PIP.
PIP on/off
PIP on
EX2&PIP} PipX2&]
Turn on PIP and display input X2&. X2& is a
two digit response (for example, 01).
PIP off
E0PIP} Pip00]
Turn PIP off.
View PIP selection
EPIP}
X2&]
View PIP selection (X2& is a two digit
response, for example, 01).
Swap main/PIP
Swap
%} Tke]
Swap between main and PIP window.
On-Screen menu conguration
Menu time-out
NOTE: Setting the time-out to 501 disables the OSD time-out (never times out). Setting the time-out to 0 disables the OSD.
Set menu time-out
EX2%MDUR} MdurX2%]
Set the OSD to X2% seconds
View time-out
EMDUR}
X2%]
View time-out settings
NOTE: X( = Enable/Disable: 0 = Off/disable, 1 = On/enable
X2% = On-screen menu time-out: (default = 3 seconds)/ Output sync time-out (default = 501 - Never)
0 = OSD never displayed/output sync is instantly disabled with no active input,
1 to 500, in 1 second increments, 501 = OSD never times out/output sync never times out
X2& = PIP window input selection: 0 to 4 (0 = Off)
X4$ = Video Signal Status: 0 = Video / TMDS signal not detected, 1 = Video / TMDS signal detected
X4& = Input signal/SDI genlock: 0 = Disabled (default), 1 = Input signal enabled, 2 = SDI genlock enabled. See command
description for details.
X4* = Input signal / genlock Status: 0 = genlock disabled, 1 = genlock enabled; not locked, 2 = genlock enabled; locked.
See command description for full details.
DVS 605 • SIS Communication and Control 46