Extron electronic DVS 605 Stereo System User Manual


 
5. While holding the connector securely against the lacing bracket, tighten the tie
wrap, then remove any excess length.
The LockIt bracket can also be used in a stacked formation, as shown below.
Side Mounted
Stacked
Figure 2. LockIt Bracket Mounting Options
d
Audio inputs 1-5 (audio models only) — Connect audio sources to these 5-pole,
captive screw connectors. Wire the connector for line level, balanced or unbalanced,
analog stereo as shown below.
Balanced Stereo Input
Tip
Ring
Tip
Ring
Sleeves
LR
Unbalanced Stereo Input
Tip
Sleeve
Sleeve
Tip
LR
Figure 3. Audio Input Connector Wiring
NOTE: Control signal ground pins are labeled “G”. Audio ground pins are as .
The wiring and function are the same, whichever way your product is
labeled.
e
HDMI output — Connect an HDMI display device to this HDMI connector.
f
RGB or HD component (R-Y, Y, B-Y) 15-pin HD video output — Connect an RGB
video display or HD component video display to this HD 15-pin connector.
NOTE: Simultaneous identical scaled outputs for HDMI and analog RGB or HD component
video are available.
g
Optional 3G-SDI/HD-SDI output connector — Connect an SDI (serial digital
interface) display to this female BNC connector for SDI output. This complies with
SMPTE 292M and 424M and ITU video digital standards.
h
Genlock connector and loop through (SDI models only) — Connect an external
reference signal for synchronization of the SDI output. The loop through can be used
to synchronize additional devices.
i
Audio output (fixed, audio models only) — Connect audio output devices to this
5-pole, captive screw connector for line level, balanced or unbalanced, analog stereo.
Wire the connectors as shown below.
Balanced Audio Output
Tip
Ring
Tip
Ring
Sleeves
Unbalanced Audio Output
Tip
No Ground Here
No Ground Here
Tip
Sleeves
LR
LR
Do not tin the wires!
Figure 4. Audio Output Connector Wiring
j
RCA audio output (S/PDIF, fixed, audio models only) — Plug in an S/PDIF audio
output device into this female RCA connector. This connector outputs digital S/PDIF
audio formats (2-channel LPCM, Dolby Digital, or DTS).
DVS 605 • Rear Panel Connections 9