Filter
Top Products
The DVS 605 Menu System — Conguration and Adjustments
Scaler configuration and adjustments can be performed by using the embedded web
pages (see “Using Default Web Pages” section), the Windows-based control program (see
the “Extron Congurator” section), the Extron Simple Instruction Set (SIS
™
) of commands
(see the “SIS Communication and Control” section), or by using the front panel controls
and the menus displayed on the DVS unit’s LCD screen. These menus are used primarily
when the scaler is first set up.
Menu Navigation Using Front Panel Controls
Menu button — Press the Menu button to activate menus and scroll through the eight
main menus.
Next button — Press the Next button to move between the submenus of a selected main
menu item.
Adjust ([,{) knobs — In configuration mode, rotate the Adjust horizontal ([) knob
and Adjust vertical ({) knob to scroll through submenu options and to make adjustment
selections. See the owcharts in this chapter for explanations on knob adjustments.
Menu Overview
After start-up, and when no adjustments are actively being made, the “default cycle”
appears on the LCD. The screens cycle between the screen that shows the active input’s
number and video format and the current output resolution.
Pressing the Menu button once brings up the first of eight main (top level) menus, as
shown below. Each successive press of the menu button goes to the next main menu.
Menu
Menu
Menu
Menu
Menu
Menu
USER
PRESETS
INPUT
CONFIG
PICTURE
CONTROL
OUTPUT
CONFIG
AUDIO
CONFIG
ADVANCED
CONFIG
VIEW COMM
SETTINGS
EXIT MENU?
PRESS NEXT
Menu
Menu
Menu
Menu
Next
Next
2
sec.
2
sec
.
Default Displa
y
Cy
cle
IN
R
G
BHV
#
1
640
x
480
IN
3
1.47 kH
z
#1 59.94 H
z
OU
TP
U
T
720p
@
6
0
2
sec.
Figure 9. Top Level Menus
A fourth default cycle menu appears only when genlock is enabled. See the Genlock
status section (page 17) for details.
NOTE: From any menu or submenu, after 20 seconds of inactivity the DVS will save all
adjustment settings and time-out to the default cycle.
The owchart shown on the following page provides an overview of the complete menu
system, with conguration submenus and the options for each setting. In the ow charts
the use of “x”, (for example in (x) or Inx) indicates an input number.
Use the Menu button to scroll between top level menus and press Next to enter the
submenus.
NOTE: If no signal is present on the currently selected input, NO SIGNAL appears in
place of the input type, for example, INPUT 4 NO SIGNAL.
Details of each of the menus are on subsequent pages.
DVS 605 • Operation 13