Agilent Technologies E4406A Satellite Radio User Manual


 
Chapter 4 95
Making Measurements
Preparing for Measurements
Using Markers
Markers enable you to make measurements on screen. Keys in the
Marker menu control the number and types of markers you can access.
Trace keys allow you to select the trace on which you will activate a
marker. The
Search key enables you to perform an immediate peak
search and activate a marker at the peak signal.
Paths to access any of the features listed below will be found next to the
specific key listed in the key access table which begins on page 53.
Trace
The Trace keys allow you to select the trace that will be used for the
other marker keys. You can then use marker features to obtain the
results you desire. To access
Trace keys press Marker, Trace.
NOTE The selections in the Trace menu include traces on all windows for the
current measurement, including windows that are not currently
displayed.
When making waveform measurements you can activate the following
trace keys:
RF Envelope and I/Q Waveform keys.
When making spectrum measurements you can activate:
Spectrum,
Spectrum Avg, and I/Q Waveform keys. The spectrum average trace feature
places a marker on the average trace in the spectrum window.
Markers
Up to four markers can appear on the display simultaneously but only
one marker can be activated and moved at a time. This marker is called
the active marker. Press
Marker to access the keys below, except for the
Shape and Marker All Off keys, which require you to press Marker, More (1 of
2)
.
Normal - Activates a single marker on the selected trace (as set by
the trace key) in units either of frequency or time, depending on the
measurement mode that is currently active. However, if a marker
has previously been activated, that marker will persist as the default
marker until it is changed. You can change the position of the
marker through use of the front panel step keys and RPG knob.
Annotation in the active function area and the upper right hand
corner of the display indicate the value of the active marker in units
of the window which contains that marker. Pressing
Normal also
deactivates any marker delta functions which have been activated
previously.