Filter
Top Products
Chapter 1 39
Getting Started
Installing Optional Measurement Personalities
NOTE You will need to enter a license key number only if you purchase an
additional measurement personality at a later date, or if you want to
reactivate a measurement personality that has been deactivated.
Installing a License Key
NOTE Also follow this procedure to reinstall a license key number that has
been deleted during an uninstall process, or lost due to a memory
failure.
To install a license key number for the selected option, use the following
procedure:
1. Press
System, Install, Choose Option . The Choose Option key accesses
the alpha editor menu. Use the alpha editor to enter letters
(upper-case) and the front-panel numeric keys to enter numbers for
the option designation. Then press the
Done key. As you enter the
option, you will see your entry in the active function area of the
display.
NOTE You must already have entered the license key for the GSM option BAH
before you can enter the license key for the EDGE retrofit option 252.
2. Press
License Key. Enter the letters/digits of your license key. You will
see your entry in the active function area of the display. When you
have completed entering the license key number, press the
Done key.
3. Press the
Install Now key.
The message “
New option keys become active after reboot.”
will appear. If you want to proceed with the installation, press the
Yes key and cycle the instrument power off and then on. Press the No
key if you wish to cancel the installation process.
Using the Uninstall Key
The following procedure removes the license key number for the
selected option. This will make the option unavailable for use, and the
message “
Application Not Licensed” will appear in the Status/Info
bar at the bottom of the display. Please write down the 12-digit license
key number for the option before proceeding. If that measurement
personality is to be used at a later date you will need the license key
number to reactivate the personality firmware.