Chapter 2 71
Using System Features
Using Input/Output Configuration Keys
Emulated GPIB Address - Shows you the emulated GPIB
address assigned to your transmitter tester when it is a SICL
server. This address is set using the
GPIB Address key.
Ethernet Addr - Shows the Ethernet address. This is an
information only feature that can not be modified by the user.
NOTE For more information about these and other remote programming
features, refer to the programmer’s guide for your transmitter tester.
File System
Press System, More (1 of 3), More (2 of 3) to access the File System key. The
label of the
File System key shows the current amount of Used memory
and
Free memory in units of megabyte (MB).
Reference
Press the Reference menu key to activate a menu which allows you to
select an external reference, or to deactivate a 10 MHz out signal on the
rear panel.
• Freq Ref - Allows you to select an external or an internal (the
default) reference. When toggled to Ext (external) you will set the
external reference frequency by entering a value between 1 and 30
MHz. When the instrument is locked to an external reference a
green Ext Ref indicator will appear in the annunciator bar.
NOTE External reference values are persistent. This means that the external
reference frequency you select will remain active until it is changed,
even if the instrument is turned off and on, or preset. If the frequency
you have input to the rear panel external frequency connector is not the
same as the external frequency value you have manually set, a red Ext
Ref error indicator and a red Unlock error indicator will appear in the
annunciator bar.
Front Panel
Key
Level 1 Level 2 Toggle Entry
System Reference Freq Ref Int/Ext When toggled
to Ext, enter
any value
between 1
and 30 MHz
10 MHz Out Off/On