Filter
Top Products
Chapter 2 53
Using System Features
Key Locations
Key Locations
All system, service, and basic features can be located by using the key
access table below. The key access path describes the key sequence you
enter to access the particular key.
Some features can only be used when specific measurements are active.
If a feature is not currently valid the key label for that feature will
appear as lighter colored text, will be greyed-out, or will not be
displayed at all.
Table 2-1 Key Access Locations
Key Key Access Path
10 MHz Out System/Reference/
50 MHz Amptd MODE/Service/
50 MHz Ref Input/Input Port/
ADC Dither Meas Setup/More(1 of 2)/Advanced/ More(1 of 2)/
ADC Range Meas Setup/More(1 of 2) / Advanced /
Note: This feature is used when measure is set to either
spectrum or waveform.
Adjust Now System/Alignments/Align Subsystem/Align 50 MHz Reference/
Note: Requires Password
Advanced Meas Setup/More(1 of 2)
Align 50 MHz
Reference
System/Alignments/Align Subsystem/
Note: Requires Password
Align ADC System/Alignments/Align Subsystem/
Align All Now System/Alignments/
Align IF System/Alignments/Align Subsystem/
Align RF System/Alignments/Align Subsystem/
Alignments System/
Align Subsystems System/Alignments/
All View/Trace/Trace Display/
Alpha Editor The Alpha Editor is accessed by following the Menu Access
Paths that accompany the following key entries: Choose Option,
License Key, and Host Name.
AMPLITUDE/
Y Scale
Front Panel
Auto Meas Setup/More(1 of 2)/Advanced/ More (1 of 2)/Data Packing/