160 Chapter 4
Making Measurements
Using Baseband I/Q Inputs (Option B7C)
• IF Align - Select to view the IF alignment signal. This signal is
available as a diagnostic function, to check the operation of the
alignment signal in the case of alignment failure. Once selected, a
menu accessing the IF alignment signal parameters is available at
the bottom of the Input menu. Either CW, comb, or pulse signals may
be selected. Because the alignment signal is input at the IF
frequency, it is displayed on any active Spectrum (Freq Domain)
window, regardless of center frequency.
• Baseband Align Signal (ON OFF) - Select to view the baseband
alignment signal. This is available as a diagnostic function, to check
the operation of the alignment signal in the case of alignment
failure. Because the alignment signal is input at the IF frequency, it
is displayed on any Spectrum (Freq Domain) window.
The
INPUT, Input Port menu is also available under the Mode Setup
front-panel key.