Filter
Top Products
Chapter 7 Menus
95
7-2 Basic Setup Menu
4
With the SHUTTLE button held down, rotate the jog
dial or shuttle dial to change the setting.
The displays in the video panel, on an external
monitor, and in the time data display section change as
shown below when you hold down the SHUTTLE
button. In the time data display section, the currently
selected setting value flashes to indicate that you can
change it to another value.
5
Press the SET button.
This saves the new setting value, and the menu display
disappears from the video panel, the external monitor,
and the time data display section.
To abandon making a change
Press the MENU button before pressing the SET
button.
The menu display disappears from the video panel, the
external monitor, and the time data display section
without the new setting value being saved.
Resetting the menu settings to their
factory default values
To reset the current active menu settings to their factory
default values, proceed as follows.
1
Press the MENU button.
The menu appears in the video panel, on an external
monitor to which the output of the VIDEO OUT 2
(SUPER)/SDI OUT (SUPER) connector is input, and
in the time data display section.
2
Press the RESET button.
The message “INITIALIZE ALL ITEMS TO
FACTORY PRESET VALUES?” appears in the video
panel and on the external monitor.
The message “Init setup?” appears in the time data
display.
To abandon operations and return to the setup
menu display
Press the RESET button again.
3
Press the SET button.
The menu settings are reset to their factory default
settings.
Switching between 525(U) line, 525(J) line
and 625 line modes (menu item 013)
To switch between 525(U) line, 525(J) line and 625 line
operation modes, proceed as follows.
1
Press the MENU button.
2
Turn the jog dial or shuttle dial to display menu item
013 in the time data display.
BLANK LINE SELECT
ITEM-703
* ALL LINE - ---
LINE 12 - blnk
----
Cursor indicating the currently selected sub-item
Sub-item number (flashing while changing)
Display in time data display
Display in video panel and on external monitor
ITEM-001
5 sec
PREROLL TIME
Setting value
Setting value (flashing while changing)
Display in time data display
Display in video panel and on external monitor
ACCESS
SHUTTLE JOG
THUMB
NAIL
ESSENCE
MARK
MENU
S.SEL
SET
RESET
SHIFT
TOP F REV
ALL/CH-1 CH-2 CH-3 CH-4
TC
F FWD
AUDI O
END
REC
PRESET
VARIABLE
PB
PREV NEXTPLAY STOP REC
CLIP
MENU
SYSTEM
MENU
MONITOR
SEL
METER
SEL
HOLD
COUNTER
SEL
SUB
CLIP
MARK1
MARK2
IN
OUT
KEY INHI
ON
OFF
NETWORK
LOCAL
REMOTE
F-RUN
R-RUN
PRESET
REGEN
INT
EXT
RP188
L/ST/R
132