Filter
Top Products
121
8-2 Condensation / 8-3 Error Messages
Chapter 8 Maintenance and Troubleshooting
8-2 Condensation
When this unit is moved from a cold place to a warmer
place, or operated in high humidity, condensation may
form on the optical pickup. This is called condensation,
and if the unit is operated in this state, it may make correct
recording and playback impossible.
Note the following points, to avoid problems with
condensation.
• When moving the unit under conditions in which
condensation is likely, first insert the disc, and close the
lid on the disc slot.
• If when you move the on/standby switch to the ` position
the indication “HUMID” appears in the status display,
do not insert a disc until the indication disappears.
8-3 Error Messages
Error codes appear in the time data display when an error
(usually a hardware problem) occurs. Error codes and error
messages appear in the video panel, and on an external
monitor to which the output of the VIDEO OUT 2
(SUPER)/SDI OUT (SUPER) connector is input.
When an error message appears, follow the instructions in
the error message to resolve the problem.
AN ERROR HAS BEEN
DETECTED. INFORM SERVICE
OF FOLLOWING CODE:
50-010
PRESS EJECT KEY
TO EJECT DISC.
ERROR
Error code
Display in time data display
Error code
Display in video panel and on external monitor