Filter
Top Products
Chapter 8 Maintenance and Troubleshooting
123
8-4 Alarms
When the unit is powered on
a) With respect to setting of basic menu item 016
When a disc is inserted
Message in time
data display
Display
condition
a)
Description Action
MENU Ver.UP on, limit, off Setup menu settings were reset,
because this unit was upgraded.
Reset the setup menu items.
See 7-2-2 “Basic Menu Operations” (page
94) and 7-3-2 “Extended Menu Operations”
(page 108) for information about making
setup menu settings.
Maintenance menu item “SETUP
MAINTENANCE” - “SAVE MENU DATA/
LOAD MENU DATA” (see page 113) can be
used to temporarily back up and restore the
current menu settings.
ILL. SETUP! on, limit, off Setup menu data is invalid, or data
recalled with the maintenance menu
item “SETUP MAINTENANCE” –
“AUTO BANK RECALL” is invalid.
Reset the items in the setup menu.
Exchg batt! on, limit, off NVRAM battery is exhausted. It is time to exchange the battery on the
board. Contact your Sony service
representative.
LOW BATT! on, limit, off Battery pack power is low. Exchange with a charged battery pack.
See 3-2-3 “Using a Battery Pack” (page 33)
for more information about exchanging
battery packs.
BATT EMPTY! on, limit, off Battery pack power is exhausted.
Message in time
data display
Display
condition
a)
Description Action
Unknown FS! on, limit, off The loaded disc was formatted by an
unknown file system.
Eject or format the disc.
See 3-6-5 “Formatting a Disc” (page 39) for
more information about formatting.
No FS! on, limit, off The file system cannot be detected. Eject the disc.
ILL. Disc! on, limit, off An unsupported disc was inserted.
Salvage NG on, limit, off Recovery of disc contents (salvage)
failed.
See 3-6-7 “Handling of Discs When
Recording Does Not End Normally
(Salvage Function)” (page 40).
525/60 Clip on, limit A disc recorded in NTSC format was
inserted when this unit is in 625 line
mode (PAL system).
Use a disc recorded with the PAL system.
625/50 Clip on, limit A disc recorded in PAL format was
inserted when this unit is in 525(U) or
525(J) line mode (NTSC system).
Use a disc recorded with the NTSC
system.
IMX50 Clip
IMX40 Clip
IMX30 Clip
DVCAM Clip
on, limit The recording format of the loaded disc
differs from the format specified with
basic menu item 031 “RECORDING
FORMAT.”
To record on the disc, change the setting of
basic menu item 031.
See 7-2-2 “Basic Menu Operations” (page
94) about how to change this setting.