Filter
Top Products
Chapter 8 Maintenance and Troubleshooting
124
8-4 Alarms
a) With respect to setting of basic menu item 016
During playback
a) With respect to setting of basic menu item 016
During control panel operations
4CHx24 Clip
8CHx16 Clip
on, limit The number of channels and quantizing
bits of the loaded disc differ from the
specifications of maintenance menu item
“AUDIO CONFIG” - “DATA LENGTH.”
To record on the disc, change the setting of
maintenance menu item “AUDIO CONFIG”
- “DATA LENGTH.”
See 7-4-2 “Maintenance Menu Operations”
(page 114) about how to change this
setting.
No Support! on, limit, off A disc recorded in an unsupported
recording format was inserted.
Use a disc recorded in the MPEG IMX or
DVCAM format.
ILL. Index! on, limit, off An index file error was detected. Format the disc.
For details, see 3-6-5 “Formatting a Disc”
(page 39).
FORMAT NG! on, limit, off Automatic format failed. Use another disc.
DI read err on, limit, off A disc read error occurred. Try ejecting the disc and inserting it again,
or insert another disc.
DRV ADJ err on, limit, off Adjustment processing failed when a
disc was inserted.
Message in time
data display
Display
condition
a)
Description Action
Message in time
data display
Display
condition
a)
Description Action
525/60 Disc on, limit An attempt was made to play back a disc
recorded with the NTSC system when
this unit is in 625 line mode (PAL
system).
Use a disc recorded with the PAL system.
625/50 Disc on, limit An attempt was made to play back a disc
recorded with the PAL system when this
unit is in 525(U) or 525(J) line mode
(NTSC system).
Use a disc recorded with the NTSC
system.
Disc Error! on, limit, off Normal playback is not possible because
of a disc defect.
Use another disc.
You can check the state of a disc by
checking playback condition marks (see
page 36).
Message in time
data display
Display
condition
a)
Description Action
KEY INHI.! on An operation button inhibited by
extended menu item 118 “KEY INHIBIT”
was pressed while the KEY INH
indicator was lit.
Set the corresponding sub-item of
extended menu item 118 to “off.”
See 7-3-2 “Extended Menu Operations”
(page 108) about how to make this setting.
REMOTE! on A button was pressed while the remote
control switch was set to “REMOTE.”
To operate from the front panel, wait until
control by the remote device ends and then
set the remote control switch to “LOCAL.”