Filter
Top Products
Chapter 7 Menus
90
7-2 Basic Setup Menu
7-2 Basic Setup Menu
7-2-1 Items in the Basic Setup Menu
The basic menu items (excluding the items related to the
digital hours meter) are listed in the following table.
• Item names are the names which appear in the video
panel and on an external monitor, when the input signals
to the monitor are the video signals output from the
VIDEO OUT 2 (SUPER)/SDI OUT (SUPER)
connector.
An abbreviated name appears in the time data display
section when you press the NEXT button.
• The values in the Settings column are the values which
appear in the time data display section. (The values may
appear in a different format in the video panel and on an
external monitor. In this case, the video panel values are
shown in parentheses.) Underlined values are the factory
defaults.
Item number Item name Settings
001 PREROLL TIME 0 s (0 sec)... 5 s (5 sec)
... 30 s (30 sec): Set the preroll time to between 0
and 30 seconds in steps of 1 second.
A preroll time of at least 5 seconds is recommended when using this
unit for editing.
002 CHARACTER H-POSITION Adjust the horizontal screen position (as a hexadecimal value) of the text
information displayed on the monitor.
a)
00... 0A ...2A (525(U)/525(J) line modes) /00... 09 ...29 (625 line mode):
The hexadecimal value 00 is for the far left of the screen. Increasing the
value moves the position of the characters to the right.
a)Video panel and external monitor (when the input signals to the monitor are the
video signals output from the VIDEO OUT 2 (SUPER)/SDI OUT (SUPER)
connector)
Set this item by adjusting to the required position while viewing the monitor.
003 CHARACTER V-POSITION Adjust the vertical screen position (as a hexadecimal value) of the text
information displayed on the monitor.
a)
00... 2E ...38 (525(U)/525(J) line modes)/00... 37 ...43 (625 line mode):
The hexadecimal value 00 is for the top of the screen. Increasing the
value lowers the position of the characters.
a)Video panel and external monitor (when the input signals to the monitor are the
video signals output from the VIDEO OUT 2 (SUPER)/SDI OUT (SUPER)
connector)
Set this item by adjusting to the required position while viewing the monitor.
005 DISPLAY INFORMATION
SELECT
Determine the kind of text information to be displayed on the monitor.
a)
off (display off): Do not output text information.
T&sta (time data & status)
: Time data and the units status.
T&UB (time data & UB): Time data and user bit data. (When UB (user bit
data) is selected with the COUNTER SEL button, the user bit data and
time data arranged in that order are displayed.)
T&CNT (time data & CNT): Time data and counter count. (When
COUNTER is selected with the COUNTER SEL button, the counter
count and time data arranged in that order are displayed.)
T&T (time data & time data): Time data and time code (TC or VITC).
T&clp (time data & clip name): Time code and clip name
time (time data only): Time data only.
a)Video panel and external monitor (when the input signals to the monitor are the
video signals output from the VIDEO OUT 2 (SUPER)/SDI OUT (SUPER)
connector)