Filter
Top Products
Chapter 7 Menus
115
7-4 Maintenance Menu
4
Press the g button.
A lower-level menu (setting modification screen)
appears. The current setting is highlighted, and the
arrow (C) flashes to indicate that you can move to a
higher-level menu. If the current setting is the factory
default, a colon (:) appears between the item name and
the setting. A midpoint (•) appears if you change the
factory default setting to another value and then
display the setting modification screen again.
To return to the menu item
Press the G button.
When there is a sub-item
Repeat steps 3 and 4 until the setting modification
screen appears.
5
Using the F/f buttons to select the desired setting.
6
Press the SET button.
This saves the new setting, and the menu disappears
from the video panel or an external monitor.
To cancel changing a setting
Before pressing the SET button, press the MENU
button.
The menu disappears from the video panel or an
external monitor, without saving the new setting.
To change network settings
To change network settings, carry out steps 1 to 3 in the
procedure of “Basic maintenance menu operations” above,
to display the NETWORK CONFIG menu item, then carry
out the following operations.
For details of the settings, consult your network
administrator.
When the IP address is assigned automatically
Check that the network cable is connected to this unit
before carrying out the operation.
1
Using the F/f buttons to select “DHCP.”
2
Press the g button.
3
Press the f button to select “ENABLE.”
4
Press the SET button.
To check the assigned IP address
In the NETWORK CONFIG menu, using the F/f
buttons to select “IP ADDRESS,” then press the g
button.
Note
If the IP address cannot be assigned, this is shown as
“000.000.000.000.” In this case, consult the network
administrator.
To set the IP address
First set DHCP to “DISABLE.” (See the previous item,
“When the IP address is assigned automatically.”)
* DISABLE
DHCP : dis
NETWORK CONFIG
MAINTENANCE MENU
ENABLE
T
Flashes
Setting modification screen
Indicates a factory default setting
Indicates that the current setting is
the factory default (change to “•” if
the default setting is changed)
Current setting
ACCESS
SHUTTLE JOG
THUMB
NAIL
ESSENCE
MARK
MENU
S.SEL
SET
RESET
SHIFT
TOP F REV
ALL/CH-1 CH-2 CH-3 CH-4
TC
F FWD
AUDI O
END
REC
PRESET
VARIABLE
PB
PREV NEXTPLAY STOP REC
CLIP
MENU
SYSTEM
MENU
MONITOR
SEL
METER
SEL
HOLD
COUNTER
SEL
SUB
CLIP
MARK1
MARK2
IN
OUT
KEY INHI
ON
OFF
NETWORK
LOCAL
REMOTE
F-RUN
R-RUN
PRESET
REGEN
INT
EXT
RP188
L/ST/R
21,3
4
ACCESS
SHUTTLE JOG
THUMB
NAIL
ESSENCE
MARK
MENU
S.SEL
SET
RESET
SHIFT
TOP F REV
ALL/CH-1 CH-2 CH-3 CH-4
TC
F FWD
AUDI O
END
REC
PRESET
VARIABLE
PB
PREV NEXTPLAY STOP REC
CLIP
MENU
SYSTEM
MENU
MONITOR
SEL
METER
SEL
HOLD
COUNTER
SEL
SUB
CLIP
MARK1
MARK2
IN
OUT
KEY INHI
ON
OFF
NETWORK
LOCAL
REMOTE
F-RUN
R-RUN
PRESET
REGEN
INT
EXT
RP188
L/ST/R
2,31,3
4,673